steel member

The aftermost transverse structural member in a steel ship, including the floor, frame, and beam assembly at the sternpost. Half-round bars for protection of lines to be provided at transom stern, poop deck, forecastle deck, and partly on the bulkhead.

船尾构架铁船中最靠近船尾的横向组成部分，包括在船尾柱附近的甲板、肋骨和横梁上为保护缆绳免受损伤，在艉封板后、尾楼甲板、艏楼甲板和部分舱壁处应装有半圆钢。

Mechanical Principle in Crossing Web Member of Cold-formed Steel Triangular Transmission Towers

冷弯薄壁型钢三角形微波通信塔斜杆受力机理研究

A hysteretic model and test verification for space steel member with consideration of the damage cumulation effects

空间钢构件考虑损伤累积效应的恢复力模型及试验验证

The Basic Theoretical Study of H-section Axial Compressed Steel Member in Confined Buckling

H型截面轴心受压钢构件限制失稳的基本理论研究

In the method, control equations for the crack resistance capacity of the normal section are established, thus the area of prestressed steel tension member may be calculated.

该方法首先建立了构件在正常使用极限状态下的抗裂性能控制方程，并以此求解预应力筋的面积；

Direct calculation method for axially compressed steel member

钢轴心受压构件截面的直接计算法

Fusion bonded epoxy coating as a member of high performance coating family has been widely used for corrosion protection of steel pipeline and pipe pile.

熔融结合环氧粉末涂层的综合防护性能优良，已经大量应用于钢质管道和钢管桩，也很适合于钢筋的保护。钢筋表面涂装环氧涂层可用静电喷涂方法，工艺基本成熟。

Assumption uniform sectional temperature and empirical formula elevated temperature in large space fire boundary condition the temperature-time curve of steel member can be derived from the solution of heat equilibrium equation which bases on the lumped differential formulation.

假定钢构件截面温度均匀分布，将高大空间建筑火灾中的实用空气升温曲线作为构件升温边界条件，对集总热容法建立的热平衡方程求解，得出钢构件在火灾下的温度-时间曲线。

Based on the theory of heat transfer, radiation between fire and the steel structural member in indoor fire was analyzed, together with the convection conditions on the boundary of the member and the conduction model within it were also confirmed.

根据传热学原理，分析了室内火灾条件下火源与构件之间的辐射传热关系，讨论了构件边界对流换热条件以及确定了构件内部的导热模型。

The steel member is chromium plated on those surfaces with which the seal interacts.

钢质零件上与密封唇接触的表面以镀铬.

We are one of the supplier member of the network units of Sinopec, CNPC and the units of China Iron and Steel Industry Association Parts Center.

成为中石化、中石油一级供应商网络成员单位及中国钢铁工业协会配件中心成员单位。

Simple Methods of Calculating the Section Area of the Vertically-Pulled Steel in the Bending Member on the Rectangle Section of Steel Concrete

钢筋混凝土矩形截面受弯构件纵向受拉钢筋截面面积的简便计算方法

Based on the general seismic design rule of structures, which is strong joint, weak member, another seismic design concept for steel structural end-plate connections, which is strong connection, weak plate is pnt forward.

本文还在“强节点，弱构件”抗震设计一般原则的基础上提出了“强连接，弱板件”的端板连接抗震设计概念。